Evidence notes before you compare
- Unresolved source conflict: product page says 10 kW NG and 334 lb; specification sheet A0005151081 Rev. D (08/13/2026), page 4, says 9 kW NG and 344 lb. Engine naming also differs on the bundled page. These disputed fields are withheld pending manufacturer clarification.
- The specification sheet describes the 10 kW included switch as limited-circuit and also uses service-rated wording in a note. Service-entrance suitability remains unconfirmed here.
THE BUYER DECISION
Could Generac G0073210 work for your home?
Documented output: 10 kW LP. The final choice depends on actual loads, starting demand and your chosen fuel.
Transfer equipment: An ATS is listed for this exact configuration; verify the switch model, current rating and service-entry suitability in writing.
Do not buy yet if: the local installer cannot verify load fit, fuel delivery, commissioning, current warranty and service coverage for the exact model.
Not a recommendation to purchase or a tested field-reliability assessment. Missing manufacturer data remains unknown.
Exact-model snapshot
Generac G0073210 — Standby Generator, 10kW | Transfer Switch Bundle | Generac.
| Product family | Cellular standby |
|---|---|
| Published standby output | 10 kW LP |
| Dimensions | 46.4 × 26.3 × 30.7 in (L × W × H) |
| Electrical configuration | 240 V rated (manufacturer specification) · Single phase · 60 Hz |
| Enclosure | Aluminum |
| Manufacturer page | Open exact product page |
Fuel-use data: keep load and units attached
The current source registry contains the following manufacturer-published test points. These are not a household fuel forecast; actual consumption changes with electrical load, fuel conditions, setup and runtime.
| Fuel | Load | Published consumption |
|---|---|---|
| LP | 50% | 0.94 gal/hr |
| LP | 100% | 1.6 gal/hr |
| Natural gas | 50% | 98 ft³/hr |
| Natural gas | 100% | 132 ft³/hr |
Sound data: mode and measurement conditions matter
- 61 dB(A) — normal load, at 23 ft; measured from the front; other sides may be higher.
- 49 dB(A) — Quiet-Test low-speed exercise, at 23 ft; measured from the front; other sides may be higher.
Manufacturer values are not an independent head-to-head acoustic test. Installation geometry, reflective surfaces, load and operating mode can change what a listener experiences.
Price, transfer-equipment scope and warranty
Starting price: $4,619 USD
Published equipment/package starting MSRP; installation, taxes and local project scope are not included by this record.
Transfer equipment: Manufacturer identifies an included transfer-switch bundle; exact switch details are listed below where verified.
Warranty summary: Product page states a 5-year limited warranty. Full contract, hour limits, labor, travel and exclusions require confirmation.
Structured ATS record: Included: Yes · Model: A0009102580 · Amperage: 100 · Service entrance: Not verified.
Load management: Exact module compatibility and included accessories not verified.
Monitoring: Built-in cellular Mobile Link; product page notes that some alerts/functions require a premium subscription.
Cold-weather accessories: Listed accessories: G007211-0 battery heater and G007102-1 oil heater when temperatures regularly fall below 32°F; G007103-2 breather heater below 0°F. Confirm applicability to the purchased serial number.
Warranty hour limit: Only established where expressly included in the cited summary above; otherwise unknown.
A product-page MSRP is not an installed-project price. Site work, ATS/service equipment, fuel work, electrical work, permits, load management, accessories, commissioning and local labor can materially change the total.
Field-level source map
Published facts below are attributed to the cited manufacturer source. A product document is not independent performance evidence. Missing fields remain unknown.
- display Name — manufacturer source
- family — manufacturer source
- ratings Kw — manufacturer source
- starting Msrp Usd — manufacturer source
- dimensions In — manufacturer source
- enclosure — manufacturer source
- fuel Consumption — manufacturer source
- warranty — manufacturer source
- monitoring — manufacturer source
- transfer Switch — manufacturer source
- ats — manufacturer source
- electrical — manufacturer source
- sound — manufacturer source
- cold Weather — manufacturer source
Current evidence gaps: engine, weight lb, load management, natural gas rated output, warranty hour limit, full warranty exclusions, certifications not independently verified.
- specification — linked manufacturer document; applicability and revision must be checked for the purchased unit.
- owner Manual — linked manufacturer document; applicability and revision must be checked for the purchased unit.
What the manufacturer sources do not prove
- They do not establish field reliability or failure rate versus another brand.
- They do not prove the quality or availability of local dealer/service support.
- They do not size a specific home or prove that every desired load can run simultaneously.
- They do not convert starting MSRP into a complete installed quote.
- They do not make unlike sound-test conditions directly comparable.
- They do not replace the current installation/operator manuals, local code, utility/fuel requirements, or a qualified property-specific assessment.
Questions to put beside this exact model in a quote
- Is G0073210 the exact generator being supplied, or can the contractor substitute another model?
- Which fuel and published standby rating are being used in the load analysis?
- What exact ATS / transfer-equipment model is included?
- Which load-management modules or accessories are included?
- Which current warranty documents apply to the generator and ATS?
- Who performs commissioning, scheduled service and warranty repairs locally?
- Which site, fuel, electrical and permit items are excluded or allowances?